CO2 Fire Extinguisher 9 Litres
Foam Fire Extinguisher
Plain annealed copper conductor Cl.1, to BS EN 60288.
Insulation of high performance Silicone rubber.
EI 2 to BS 7655 Section 1.1.
Core colours:
2 Core : blue, brown.
3 Core : blue, brown, black.
4 Core : blue, brown, black, grey.
Earth/Drain wire of annealed tinned copper Cl.1 to BS EN 60228.
Electrostatic screen of aluminium fire barrier with 125 % overlap.
Sheath Type LTS3 to BS 7655 section 6.1.
Fire Alarm Panels
‘Normal’, ‘Defect’ and per circuit ‘Fire’ indication on front panel
‘Internal Bell Cut-Off’ and ‘External Bell Cut-Off’ (BCO)
Alarm reset available from a front panel key-switch
Trial Evacuation key-switch
Fire & Defect C/O relays with Fire relay Isolate switch
Automatic Alarm Verification Facility (AVF) provides substantial
protection against transient false alarm activation
Supervised bell circuit with 10 kΩ EOL resistor
Maximum of two 20 Watt 100 Vrms line amplifiers with voice
evacuation message
‘Battery Absent’ detection circuitry
Earth leakage supervision
Integrated Alarm and Defect piezo for audible warning
On-board System ‘Defect’ LED indicates source of fault
Door Interlock
Brigade ‘Isolate’ and ‘Test’ switches
Electrically isolated interface to an alarm transmitter (SGD)
DBA mode ‘Non Latching, Bell Only’ configuration available (on Circuit 4)
Automatic daily load test with automatic ‘Battery Absent’ detection circuitry
Fire Blanket 1.8m x 1.8m
Foam Fire Extinguisher
FP200 Gold Prysmian 1.5mm² Fire Resistant Alarm Cable
Manual Fire Alarm Break Glass
Red Fire Alarm Bell
Smoke Detector
- Wireless and addressable smoke detector, no wiring is needed
- 3V Lithuim battery, over 3-year battery life
- Working with wireless alarm panel,
- notify owner or call CMS when alarm is triggered.
- Complies with EN14604 and UL217 standard
- Vds and UL approved
- Compatiable with LS-10, LS-20, LS-30 panel
- Optional Smoke + Heat Detector
- CE, FCC, RoHS
2 Zone Fire Alarm Control Panel AW-CFP2166-2 Asenware
AW-CFP2166 series conventional fire alarm panel is designed based on EN54 part 2&4 standard.
2. It is modularized design, the panel can extend from 1 zone to 32 zones easily.
3. It has 2 level control mode by a lock
4. It has 24VDC and 5VDC power supply output.
5. It has FIRE and FAULT signal output.
6. It has 2 general sounders output.
7. Each zone has 1 circuit detectors input.
8. Each zone can be disable by a button.
9. It has RESET button to reset the panel.
10. It has SILENCE button to stop BUZZER and SOUNDERS.
11. It has EVACUATE button to start a manual fire alarm immediately.
12. It has battery low protection function, when battery voltage lower than 21VDC, battery will be cut off automatically until the mains power is on.
